Did you know that…?

In our cutting section 2500 kgs of sheet metal are processed every day. It is mainly iron, stainless steel and aluminum in different formats.

With a capacity of 40 m. per minute, our fiber and Co2 lasers get to cut sheets of sheet metal of 4 x 2 m. and up to 20 mm. of thickness in iron and 12 mm. in stainless steel.

 
Knowing the process FMEA

During this month several trainings are being carried out to our workers on quality control and, specifically, on failure mode and  effects analysis (FMEA) applied to production processes.

In these meetings we analyze the potential failure modes of our products and their associated causes. As always, the priority objective that COFINOX pursues is the improvement of quality to fully satisfy the customer.

 
<< Start < Prev 1 2 3 4 5 6 7 8 9 10 Next > End >>

Page 1 of 17
Cofinox 2018